23
Setting the temperature display to Celsius or Fahrenheit
.
Press and release the + or - button to toggle between C and F.
When the display shows the desired symbol, press and releases the “SET” button to store.
As the important settings above have now been done. Press and hold (not releasing straight
away) the “SET” button for a few seconds and this will exit the setup menu.
The control is now ready for use with the Fire Control.
Quick start user instructions
First set up the hand set, cup the handset
the green unlock light will illuminate.
Keep it held
to keep the control unlocked, to enable operation of the buttons.
Then with the other hand touch and keep you finger on the power button for about 5 seconds.
(Upon touching the power button the green light will do a
single flash
to show command is
recognized – after 5 seconds the green light will flash for a second time, at which you should
release your finger). The Fire should be lit within a few seconds. (N.B. If power button is held for
more than a few seconds after second flash/beep, the command ignored for safety reasons. With
this system, the control has been designed to ensure that only intended ignition of the fire
occurs.)
To stop – with handset held to unlock it, press then release power button.