26
Control and to enter to setup the time of day on the handset. N.B. If the display returns to the
one shown above with the word “TESC” shown, then too much time has passed before pressing
“SET” and so the handset has not paired yet. Simply repeat pairing again.
Advanced settings Menu
In the event that you may want to change the other pre-set settings of the control features. Do
not do a long press and hold above but a normal short press and release will take you into the
advanced settings area.
Advanced settings options are:-
• Back light –
o A = Automatic (default setting). The back light comes on in the dark but not in the light.
o 0 = Light never comes on.
o 1 = Light comes on whenever handset is unlocked.
• Display contrast – 8 levels from 0 to 7 (default level 4).
• P = pairing with other devices other than the fire control.
The hand set can pair with other modules to:-
o L= Operate an electric light – which is the dimmable in 9 steps
o F= operate an electric fan –which can have 9 speed levels
o A= operate an auxiliary contact to operate another device.
Note:
Fitting the batteries incorrectly could lead to damaging your Valve.
Different types of batteries or old and new batteries are not to be mixed.
Only batteries of the same or equivalent type as recommended are to be used.
Batteries are to be inserted with the correct polarity.
Exhausted batteries are to be removed from the fire.
The supply terminals are not to be short-circuited.
Do not use rechargeable batteries.
Non-re-chargeable batteries are not to be recharged.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon zinc) or re-chargeable batteries.
1.
From the standing position push the thumb control all the way to the right where a spark
will be heard and generated, hold for approximately 15 seconds.
SECTION 17:
OPERATING THE APPLIANCE (Slide Control)
