101
Meusure D
2
1
Meusure T
T - D = 1 a 2 mm
c) Release the fixing nuts of the wheel and lift it by means of the jack until it is
free under the ground;
d) Remove the nuts and the wheel carefully, preventing the screw thread from
damage;
e) Take the spare wheel.
f) Every time when a wheel is removed, mounting it again, the wheel screws
should be tighten first at torque 25 kgm (250 Nm) and re-tighten then at torque
50 to 100 km. If not, they may fall off, causing an accident with severe injuries
and material damage.
Reinstallation
Before the wheel installation, make sure that the support surfaces on the rim and on
the brake drum, as well as the nuts and screws thread are clean and free of sharp
IMPORTANT: This procedure should be per formed at a Volare
Representative Office.
Wheel Replacement
Removement:
a) Activate the parking brake and block the vehicle’s wheels to avoid its accidental
movement;
b) Position the jack under the spring, near its fixation to the axle of the wheel to
be removed;