39
If this red light of the brake indicator starts glowing when the vehicle is in motion,
park your car in a safe place and find out the reason of the pressure drop.
NOTE: When the starting switch is set in position 3, this warning light
starts glowing, but it should stop glowing right after the setting of the switch in
position 2 (contact).
5- Brake and Clutch Liquid Level Light
This light starts glowing in two situations:
1- When pressure in the brake system is lower than normal; and
2- When level in the brake or clutch reservoir is lower than correct. If this happens,
check the level in the reservoir and fill up, if necessary.
6 - Engine Oil Pressure Light
The alarm light of the engine lubrication system starts glowing with
a red light when the starting switch is set in position 2, however, it
stops glowing right after the engine starting.
IMPORTANT: If this does not occur or it glows when the vehicle is in
motion, immediately switch off and find out the reason. Do not start the engine
without finding out and eliminating the failure.
7 - Alarm Light – Activated High Beam
The blue light, when starts glowing, indicates that high beam is switched
on. When see the approached vehicles, do not use the high beam,
change for the low-beam by means of the multifunctional switch.
8- Clearance Light (Lamps)
This light starts glowing when the lamps of the vehicle are activated.
9- Low-beam Light
This light starts glowing when the low beam is activated.
10- Fog Lamp Light
This light starts glowing when the auxiliary fog lamps are activated.
11- Alternator/Batter Light
When setting the contact switch in position 2 (contact), the red light of
the indicator should start glowing. When the engine starts operating,
the light must stop glowing automatically and stay switched off while
the motor is in operation.
IMPORTANT: If it starts glowing when the engine is in operation,
immediately stop and find out the cause, because this process indicates that the
battery is not receiving charge from the alternator.
