approx. 11 lbs (5 kg).
Applies to vehicles with gas discharge lamps with
dynamic headlight range control:
Note:
On vehicles with gas discharge headlights, DTC
memory should be checked and erased using
vehicle diagnosis, test and information system VAS
5051 or vehicle diagnosis and service system VAS
5052 and headlight range adjuster brought into
Basic Setting before every headlight adjustment.
Checking headlight setting (with new test screen without 15 -
setting line)
Headlights:
Check the following:
- With the low beam switched on check whether the
horizontal light-dark border of the setting line
- 1 -
contacts
the test surface.
- Check whether the break-away point
- 2 -
between the
left horizontal part and the rising part on the right of the
light-dark border runs vertically through the center point
- 3
-
. The bright core of the light beam must be on the right of
the vertical line.
Note:
To make it easier to find break-away point - 2 -
cover and uncover left half of headlight (as viewed
when looking forward) a few times. Then check low
beam again.
After correct adjustment of low beams the center
Page 13 / 46
Description of work (part 2 of 2)
