4
5
CONTROL PANEL
1. Mode Settings
– Control the power output.
Eco - 500 watts
Low - 1000 watts
High - 1500 watts
2. ActivePure Mode
– Press the ActivePure button to turn
the ActivePure cell on or off. The cell is active when the
ActivePure LED is illuminated.
3. Power Button
– Press for Power On or Off.
4. LED Display
– indicates set temperature or hours
5. Timer Button
– Press the Timer Button when the
heater is on to set the hours until the unit turns off. Or
press the Timer Button when the heater is off to set a
time for the unit to turn on automatically. Time can be
set for up to 12 hours.
6. Temperature Control
– Use the up button to set a
warmer temperature and the down button to lower the
heat.
7. Temperature Display
– As you set the temperature
higher or lower, the temperature display will indicate
the desired warmth.
1
5
6
2
3
4
7
TO RUN AS AIR PURIFIER ONLY
1. Power Unit ON using switch on back of unit .(Do not press power button ( ) on control panel)
2. Press ActivePure ( ) button on Control panel. Fan and AP Cell will run providing air purification without heating.
3. Press ActivePure button again to turn off.
