2
Conveyor Bagel and Bun Toasters Operator’s Manual – Models JT1B and JT1BH
FEATURES
OPERATION
NOTICE: The crumb tray must be installed in the toaster during
operation. Failure to install the crumb tray will cause the
toaster to overheat.
Tips
Preheat
1. Plug the toaster into a grounded electrical outlet that matches the
rating on the name plate found on the back of the toaster.
NOTICE: Using a voltage other than the nameplate rated voltage
will cause damage to the unit. Incorrect voltage,
modification to the power cord or electrical components
can damage unit and will void the warranty.
2. Rotate the power knob to the full power position (I).
3. Flip the toggle switch to appropriate setting, Top or Top-Bottom.
4. Set the conveyor speed control knob to 7.
5. Wait 5 minutes for the toaster to preheat.
Test
1. Adjust the settings for the product to be toasted. Test the settings by
placing a sample of the bread items to be toasted onto the feed
ramp. Place bagels or buns with the cut side facing up.
2. Evaluate the results.
Toast
1. Adjust the conveyor speed as needed to achieve desired browning.
• Toast too light: Rotate the speed control knob to a lower number
to reduce the speed and darken the toast.
• Toast too dark: Rotate the speed control knob to a higher number
to increase the speed control and lighten the toast.
2. For best performance do not overload the toaster. Wait a few
seconds before loading a second row of bread products into the
toaster.
If Bread Becomes Stuck
1. Rotate the power knob to the OFF position (O) and unplug the
toaster.
2. Let the toaster cool completely.
3. Use a tong to remove the bread item. Take care to not bump the
glass heating elements above and below the conveyor.
CLEANING
NOTICE: Do not use abrasive materials, scratching cleansers or
souring pads to clean the exterior of the equipment. These
can damage the finish.
NOTICE: Do not spray the controls or outside of equipment with
liquids or cleaning agents.
Daily Cleaning
1. Rotate the power knob to the OFF position (O) and unplug the
toaster.
2. Let the toaster cool completely.
3. Slightly dampen a soft cloth with warm water.
4. Use the dampened cloth to clean the exterior of the toaster, the air
intake under the toaster, the feed ramp, crumb tray and collection
tray.
5. Press and hold an abrasive pad or brush against the conveyor. Move
the pad or brush back and forth (left to right) across the conveyor to
remove food debris.
PREVENTATIVE MAINTENANCE
Contact an authorized service agent for a professional cleaning of the
components.
A
Conveyor Speed Control Knob
B
Power Knob
Full Power - Maximum heat
Off
Standby - Reduces electrical consumption by 75%.
C
Heat Shield
- Swings open on the high-clearance toasters
D Feed Ramp
E
Crumb Tray
F
Toggle Switch
- Switches between heat modes
Top
- Toasts both sides
Top-Bottom
- Toasts the top side, warms the bottom side
G Collection Pan
H Reset Button
A
B
D
E
F
C
Back View
G
H
Front View
CAUTION
Burn Hazard
Do not touch the equipment while it is heating or operating.
Hot surfaces can burn skin.
Bread Product
Suggestions
Bagels, wheat or rye bread or
products with high moisture content
Use a slower conveyor speed.
Buttered or coated, such as pastries Not recommended.
Frozen
Must be thawed before toasting.
WARNING
Electrical Shock Hazard
Do not spray water or cleaning products. Liquid could contact
the electrical components and cause a short circuit or an
electrical shock.
CAUTION
Burn Hazard
Allow equipment to cool before moving or cleaning.
