O
peratOr
’
s
M
anual
2
ENGLISH
S
afety
P
recautionS
To ensure safe operation, read the following statements and
understand their meaning. This manual contains safety precautions
which are explained below. Please read carefully.
WARNING
Warning is used to indicate the presence of a hazard that
can
cause
severe
personal injury, death, or substantial property damage if the
warning is ignored.
CAUTION
Caution is used to indicate the presence of a hazard that
will
or
can
cause
minor
personal injury or property damage if the caution is
ignored.
NOTE
Note is used to notify people of installation, operation, or
maintenance information that is important but not hazard-related.
For Your Safety!
These precautions should be followed at all times. Failure to follow
these precautions could result in injury to yourself and others.
To reduce risk of injury or damage to the unit:
Plug only into grounded electrical outlets matching the nameplate rated
voltage. Each induction unit should have a separate circuit.
Do not use an extension cord with this equipment. Do not plug this
equipment into a power strip or multi-outlet power cord.
As a precaution, persons using a pacemaker should stand back 12”
(30 cm) from an operating unit. Studies have shown that the induction
element will not disrupt a pacemaker.
Keep all credit cards, driver licences and other items with a magnetic
strip away from an operating unit. The unit’s magnetic field will damage
the information on these strips.
Do not put water in the rethermalizer. It is intended to run dry. Water will
damage the unit and void the warranty.
Use only Vollrath induction-ready insets with this unit. Failure to use
Vollrath Induction-ready insets may damage unit and void the warranty.
Do not spray controls or outside of unit with liquids or cleaning agents.
Unplug when not in use.
Keep unit and power cord away from open flames, electric burners or
excessive heat.
Do not operate unattended.
Closely supervise units operating in public areas and/or around
children.
Do not operate if unit has been damaged or is malfunctioning in any
way.
f
unction
and
P
urPoSe
The
800W models
are intended and designed to rethermalize containers of
refrigerated, previously cooked food and hold containers of hot food at safe
serving temperatures.
All Models
are intended and designed to keep food
product at proper serving temperatures. For hot food holding food must be
prepared and placed in at proper serving tempratures. These units are not
designed to cook raw food.
Use only Vollrath induction-ready insets (item 88184 or 88204). Failure to
use Vollrath Induction-ready insets may damage unit and void the warranty.
This equipment is not intended or designed to cook raw food product.
Before using this equipment it must be cleaned and dried thoroughly. This
equipment is not intended for household, industrial or laboratory use.
u
nPacking
the
e
quiPment
and
i
nStallation
When no longer needed, dispose of all packaging and materials in an
environmentally responsible manner.
1. Remove all packing material and tape, as well as any protective plastic
from the equipment.
2. Clean any glue residue left over from the plastic or tape.
Have the unit installed only by qualified service personnel. The cutout
opening in counter must be in accordance with the chart below. All openings
must be within 1/8” of the stated dimension.
Model/Size
Cut-out Opening
7 Quart
10-5/8” (27.0 cm) Diameter
11 Quart
12-5/8” (32.1 cm) Diameter
Control Box
2-5/8” (6.6 cm) x 5” (12.7 cm)
(stud locations shown below)
3-1/16”
(7.8)
13/64”
(0.51)
2-3/16”
(5.6)
2-5/8”
(6.6)
5-13/16” (14.8)
6-7/16” (16.4)
5” (12.7)
Figure 1. Control Panel Cutout
NOTE
All cutout openings must be within 1/8” of listed opening sizes.
3. Plug the power cord into a grounded electrical outlet with the matching
nameplate rated voltage.
NOTE:
Using a voltage other than the nameplate rated voltage will cause
damage to the unit. Incorrect voltage, modification to the power
cord or electrical components can damage unit and will void the
warranty.
o
Peration
WARNING
Electrical Shock Hazard.
Keep water and other liquids from entering the
inside of the unit. Liquid inside the unit could cause
an electrical shock.
NOTE:
Pre-heat empty insets for 5 minutes or less when necessary.
Because of the speed and efficiency of the induction range, insets
can very quickly overheat and be damaged.
