Vollrath Stoelting CC101A, Operator'S Manual

Page 7 

A. Cleaning 

1.  Remove the front gate and install the splashguard. 

2.  Make a cleaning solution of 1½ to 2 gallons (4-8 

liters) of cold water and the correct amount of 
cleaning solution. Do not exceed 100 degrees Fahr-
enheit (38 degrees Celsius). 

3.  Pour the cleaning solution into the hopper pan. 

Wash down the sides and bottom of the hopper pan 
to dilute remaining mix. 

4.  Turn the flow control valve to the number “2” posi-

tion to allow sanitizer into the barrel. 

5.  Turn the beater switch to “ON” and run the clean-

ing solution through the barrel.  

Make sure the refrigeration switch is in the “OFF” 
position. 

6.  Repeat the procedure until all mix residue is gone 

and the hopper pan is clean. 

7.  Turn the beater switch to the “OFF” position and 

remove the key. 

8.  Properly dispose of the cleaning solution.  

SAFETY WARNING: Do not attempt to remove the 
front plate, or beater shaft without first removing 
the key from the beater switch. Serious bodily in-
jury may result. 

B. Disassembly 

IMPORTANT: Make sure to keep the parts for 
each individual barrel separated. The parts need to 
be installed into the same barrel every time the ma-
chine is disassembled.

1. Remove 

key 

2.  Remove the front gate and front plate for washing. 

Remove the o-ring from the front plate. Remove 
front bushing from beater shaft. 

3.  Lay the washed parts out on a sanitized counter for 

air drying. With the beater shaft wrench, pull the 
beater shaft partially out of the barrel by grabbing 
behind the first blade. Continue to pull the beater 
shaft forward and remove each blade and spring 
and place in a container for cleaning.  

CAUTION: Be careful not to scratch the inside of 
the barrel with the beater shaft. 

4.  Remove the Rear Gasket and 

wipe the lubricant off the hex end 
of the beater with a clean towel. 

5.  Remove the flow control rod and 

the flow control valve assembly. 

6.  Take all parts to the cleaning area for 

washing. Add sufficient hot water and 
cleaning solution to cover all of the 
parts. Let soak for five minutes. Make 
sure mix is removed from all small, hard to clean 
areas of the parts, including o-ring grooves. 

7.  While the parts are soaking, use a cleaning solution 

and barrel brush to clean inside barrel. 

8.  Wrap a clean towel soaked 

with cleaning solution 
around a barrel brush and 
run the brush and towel 
through the barrel until it is 
clean. 

Cleaning and Disassembly