45
20.
Trouble shooting and repair
Problem
Possible reason
Corrective measures
The equipment
cannot be
started
Battery is used up
Charge
Battery not inserted correctly
Check the correct insertion of the battery in
the tool
on/off switch failure
Send to the Service Centre for repair
Intermittent
running
Internal connecting line is loose
Send to the Service Centre for repair
on/off switch failure
Tying is not
successful,
tying effect
is not good.
After tying, it is loose and not firm; Adjust gear switch to a suitable level
Unsuccessful tying due to foreign
material
Check if there are any foreign matters in
feeding track, clear up foreign matters
and unsuccessfully tied tying wire.
Incorrect or missing wire feeding
1.Check if the tying wire is stuck in feeding
tray, if it is stuck, conduct cleaning
timely.
2.Check if there are any residual tying
wires or other foreign matters in the
whole feeding track, and conduct
cleaning timely.
Tying is easily stuck by branches. 1.Operation may be too fast, please adjust
operation speed. Only after confirming
the completion of tying action the tying
machine can be lifted up.
Cannot charge
The red indicator
of charger is
blinking.
The battery is not placed in the
charger correctly.
Verify battery to charger connection
The connection of charger and
power supply is not correct.
Verify correct connection of charger to
power supply
Battery voltage is too low
Wait for 10 minutes.
Battery failure
Replace battery
Charger failure
Replace battery charger
