Correct installation of the pump:
NOTE:
Pumps are not suitable for pumping aggressive, flammable, explosive, high
viscosity liquids containing mineral oils, solid particles and fibrous impurities. Damage
to the pump caused by pressing the above-mentioned types of liquids is not subject to
warranty repairs.
4. PUMP INSTALLATION
Device should be used as intended. Each time before installing the pump,
check whether its condition allows operation in a way that does not endanger your
health or life. There are a few basic rules to remember when installing, operating and
operating:
ź
All installation work must be carried out only by specialized personnel
ź
All repairs and maintenance should be carried out only after disconnecting the pump
from the power supply
ź
Before dismantling, drain the system or close the shut-off valves at the pump inlet
and outlet, and wait until the temperature of the elements drops below 50 ° C.
ź
If individual components need to be replaced, please contact the manufacturer's
service.
ź
Any amendments introduced without obtaining authorization for this release the
Guarantor from any kind of liability.
ź
After completing the work, switch on all protective and safety devices again
Pump should be installed in a straight section of the installation. Shut-off valves
must be fitted on the suction pipe as well as the supply pipe. Please note that the system
pressure does not exceed the permissible operating pressure of the pump and that the
required flow direction is in line with the arrow on the pump body.
Pump should be installed in such a place that there is easy access to it (for
venting). The water in the installation must be treated and not silted under any
circumstances. The system should be filled with liquid and vented.
The pump is self-venting and does not need to
be vented before start-up. Air collected in the
pump can cause noise. This noise stops after
a few minutes of pump operation.
The pump is quickly vented by briefly starting
the pump in gear III, depending on the type
and size of the installation. The pump will be
vented when the noise level is significantly
reduced and it will be set according to the
instructions in the manual.
sales@voltpolska.pl (58) 341-05-06 | przemek@voltpolska.pl (58) 341-38-80 | bartek@voltpolska.pl (22) 100-42-99
