Terminal box settings can be changed as follows:
Loosen the screws connecting the motor to the pump housing
Turn the engine to the desired position
Tighten the screws again
Selection of pump setting depending on the type of installation. Factory setting = AUTO
sales@voltpolska.pl (58) 341-05-06 | przemek@voltpolska.pl (58) 341-38-80 | bartek@voltpolska.pl (22) 100-42-99
Recommended
Alternative
A
Floor heating
AUTO
B
Two-pipe installation
AUTO
C
One-pipe installations
Lowest characteristics at
proportional pressure control (PP1)
The highest characteristics when regulating
proportional pressure (PP2)
Installation type
Poz.
Pump setting
Highest characteristics w ith constant pressure control (CP2)
or low est characteristic at constant pressure control (CP1)