customersupport@voltlighting.com • 813.978.3700
–5–
Wire Connection
5
Install Horseshoe Mount
4
Anchor
Horseshoe
Mount
Mounting
Screw
Washer
Attach the horseshoe mount on
your desired location and mark (3)
points for anchors from the holes
on the horseshoe mount.
Drill proper holes on the location
and insert the anchors into the
drilled holes. Attach the horseshoe
mount onto the anchors. Pass the
washers over the mounting screws
and thread the mounting screws
into the anchors to secure the
horseshoe mount. Hand tighten
until snug with a screwdriver.
NOTE: SOME APPLICATIONS ARE NOT
SUITABLE FOR PERMANENT MOUNTING AND
DO NOT REQUIRE OR WARRANT THE USE OF
SCREWS AND ANCHORS
Thumb Screw
Wire Connector
Main Supply Wire
Pigtail
Housing
Strip both leads from the luminaire pigtail. Using two wire
connectors (sold separately), connect the leads from the
luminaire to the main supply cable leads.
Adjust the housing to your desired direction by using thumb
screws on the side of the housing.
