INSTALLATION INSTRUCTIONS
w w w . v o l t l i g h t i n g . c o m
customersupport@voltlighting.com • 813.978.3700
VOLT
®
Top Dog Downlight Cast Brass
VAL-1810-40-BBZ
Install Lamp
Install Shield and Glare Guard
2
3
Lamp
Screw
Socket
Shield
Glare Guard
Fixture
Wire Connections
5
Lay out the supply cable to the transformer. Strip both leads from the
luminaire pigtail. Connect the leads from the luminaire supply cable to
the transformer (sold separately).
Install Fixture
4
Determine the desired location
for the fixture. Pass self-tapping
screws through holes on the
surface mount. Thread the self-
tapping screws into the surface to
secure the fixture.
NOTE: For applications involving
installation in trees, use the
mounting kit with offsets. These
will allow for tree growth.
Fixture
Self-tapping Screws
Offsets (included
with mounting kit)
Insert the lamp with the correct
wattage and type marked on the
fixture label.
CAUTION: Do not exceed maximum
wattage marked on luminaire label.
NOTE: DO NOT touch lamp with
bare hands. Use soft cloth to handle
lamp.
Replace the shield over the lamp
and thread it onto the fixture.
Tighten until snug. Attach the
glare guard back onto the shield
and secure it with the provided
screw. Tighten until snug with a
screwdriver.
Fixture
Pigtail
Transformer
(sold separately)
Supply Cable
Adjust Angle of Lamp
6
Install/Replace Lamp
Unscrew the screw on the glare guard. Then remove the glare guard
and shield to expose the lamp. Replace the lamp with the correct
wattage and type marked on the fixture label. Then, reinstall the
shield and glare guard and tighten with the included screw.
IMPORTANT: Halogen lamps must be protected from moisture and dust
at all times. Always reinstall shields and glare guards when moved.
Adjustment
Screw
Loosen the adjustment screw and
adjust lamps to your desired angles
and then tighten the adjustment
screw.
