VOLT
®
Dojo Deck Light
VDL-6009-4-BBZ
Package Contents
Product Dimensions
Important: Please Read Before Installation
Important Safety Instructions
INSTALLATION INSTRUCTIONS
This fixture is intended for installation in accordance with local codes and
the National Electric Code (NEC). Failure to adhere to these codes and
instructions may result in serious injury, property damage and void the
warranty.
These instructions do not intend to cover all variations in installation,
operation maintenance or mounting situations.
1. Make sure that the power is turned OFF before installing or servicing
this fixture.
2. Warning: this fixture is not intended to be installed within 10 feet [3
meters] of a pool, spa or fountain.
3. This fixture is intended to be connected to a low voltage transformer.
4. Underground Low Energy Cable must not be buried over 6” (15.2 cm)
in order to connect to the main low voltage cable.
5. Wire connections must be made with UL listed wire connectors that
are suitable for outdoor use.
LIGHTED LAMP IS HOT!
WARNING – TO REDUCE THE RISK OF FIRE OR INJURY TO PERSONS.
1. Turn off/unplug and allow to cool before replacing lamp.
2. Lamp gets HOT quickly!
3. Do not touch the hot lens, guard or cowl.
4. Keep lamp away from materials that may burn.
5. Do not touch lamp at any time.
6. Use a soft cloth.
7. Oil from skin may damage lamp.
8. Do not operate the fixture with a damaged or missing lens or shield.
A. (1) Fixture Body
!
!
w w w . v o l t l i g h t i n g . c o m
customersupport@voltlighting.com • 813.978.3700
3”
B. (2) Lock Screw
3.5”
- 3 -
- 2 -
ProTip for Hiding Splice Connections
ProTip for Hiding Lead Wire
Determine the location for the fixture. Drill a hole straight through the
desired mounting location and run the lead wire out the backside of
the location so that the wires are not visible from the front side. Use a
matching trim piece and cut a groove in the back of trim. Cover the lead
wires with the matching trim piece.
All fixtures come with 4’ of lead wire enabling you to hide the splice
connections out of sight. If you must make a splice connection in view, use
an inline heat shrink style connection that is less visible than traditional
twist caps.
1.75”
