w w w . v o l t l i g h t i n g . c o m
- 6 -
customersupport@voltlighting.com • 813.978.3700
- 7 -
Install Fixture
3
Wire Connections
4
VOLT
®
Floodlight with Motion Sensor
VFL-40XX-MS-ABZ
Fixture
Yoke Mount
Bolt
Hex Nut
Washer
Wall
Remove the hex nuts and the
washers from the wall anchors.
Attach the yoke mount of the
fixture to the wall anchors and
secure them in place with the
previously removed washers and
hex nuts. Tighten until snug.
Adjust Fixture and IR Sensor
5
Wall
Fixture
Set Screw
IR Sensor
Wrench
Adjust the fixture to your desired
orientation and tighten set screws
with a wrench.
Adjust the IR sensor to proper
orientation.
After installation, but before power is on:
A. Check whether the lighting fixture is firmly fixed.
B. Check whether wires are connected properly.
Infrared (IR) Sensor
max.
11.48 Ft.
min.
6.56 Ft.
This product can be installed outdoors. It is recommended to install in
these orientations to protect the flood light against heavy rain.
INSTALLATION INSTRUCTIONS
Fixture
Strip both leads from the fixture pigtail and main supply cable.
Using two wire connectors (sold separately), connect the leads from
the fixture to the main supply cable leads.
Wire Connectors
Pigtails
Main Supply
Cable
Supply Cable
from Fixture
