INSTALLATION INSTRUCTIONS
customersupport@voltlighting.com • 813.978.3700
Adjust Fixture Body
4
Use the included Allen wrench to
unlock the set screw and adjust
the fixture body to your desired
direction. Tighten the set screw
once your desired angle is achieved.
Fixture
Body
Allen
Wrench
Set Screw
Adjust
w w w . v o l t l i g h t i n g . c o m
- 4 -
- 5 -
Clear away an area on the ground
at the wireway slot on top of
the stake. Lay the luminaire
pigtail into the wireway slot and
thread the fixture onto the stake.
Tighten using the lock nut to
secure it to the base.
Install Fixture Body to Stake
2
Fixture Body
Pigtail
Wireway Slot
Stake
Wire Connections
3
Strip both leads from the luminaire pigtail. Using two wire connectors
(sold seperately), connect the leads from the luminaire to the main
supply cable leads.
Pigtail
Main Supply Cable
Wire Connectors
Remove Glare Guard with Lens
Replace Lens
1
2
Loosen the thumb screws, then
remove the glare guard and the lens
from the fixture body.
Remove the lens from the rubber
gasket, then replace it with the lens
you would like to use.
Fixture
Body
Glare
Guard
Glare
Guard
Thumb Screw
Gasket and
Lens
Replace Lens
VOLT
®
Integrated LED Gentle & Big Splash
VFL-4601-BBZ & VFL-4602-BBZ
