54
RS232 Interface
At the back of the measuring device, an optically isolated interface is located. It serves to transfer data to
a PC for further processing.
The data connection to a free interface of your computer can be created with optional serial data cables
(RS232 or USB).
Slide the interface cover (11) from the housing upwards. Align the wedge-shaped adapter of the optional
interface cable flush with the housing groove (11) at the measuring device from above.
The interface is switched off in normal operation. To activate it, keep the “REL/PC” button pressed fro 2
seconds when the DMM is switched on. Activation is indicated by the interface symbol
and a short
beep. For deactivating, keep the “REL/PC” button pressed for approx. 2 s or switch off the DMM.
The optional data cables are available under the following order no.:
Order No. 12 56 40 RS232
Order No. 12 03 17 USB
Display illumination
The display can be lighted in low light. Lighting turns of automatically after approx. 10s.
For switching it on, hold down the “LIGHT” button (10) for about 2 seconds. For switching off the lighting
prematurely, keep the “LIGHT” button pressed again for approx. 2 s or switch off the DMM.
Cleaning and Maintenance
General
To ensure the accuracy of the multimeter over an extended period of time, it should be calibrated once a
year.
Apart from occasional cleaning and fuse replacements, the meter requires no servicing.
Information on changing the battery and fuse is provided below.
Regularly check the technical safety of the instrument and measuring lines, e.g.
check for damage to the housing or squeezing etc.
Summary of Contents for VC870
Page 3: ...3 ...
Page 125: ...125 ...
