25
8. INSERTING/CHANGING THE BATTERIES
Batteries are not normally inserted when the product is delivered to you. Follow the steps
below to prepare the product for use.
Using rechargeable batteries is not recommended due to their low voltage.
Low battery:
• < > appears on the display.
• The backlight is dim or off altogether
If only the < > symbol is displayed after turning on the device, the batteries must be replaced
immediately.
Replace the batteries as soon as possible according the following steps:
1. Turn off the device and disconnect it from any measuring objects. Refer to chapter
"9. Operation" on page 26.
2. Turn the device over and place it on a soft surface that will protect the display from
scratches.
3. Loosen the screw on the battery compartment cover (5) using a suitable Phillips
screwdriver. Remove the battery compartment cover.
4. Remove the old batteries and dispose of them in an environmentally-friendly manner.
Refer to chapter "11. Disposal" on page 30.
5. Place two new AAA batteries into the battery compartment, paying attention to the polarity
markings.
6. Replace the battery compartment cover (pay attention to the tab) and screw it into place
with the screw. Do not use any force.
Summary of Contents for 1307543
