69
Afterwards, you can select the different functions with the buttons „INC“ and „DEC“.
• „CHARGE“: Charge lithium battery without balancer connection
• „BALANCE“: Charge lithium battery with balancer connection
• „FAST CHG“: Fast battery charging
• „STORAGE“: Charging/discharging batteries at a set voltage value
• „DISCHARGE“: Discharging the battery
b) Charging Batteries without Balancer Connection („CHARGE“)
• After selecting „CHARGE“, the following display appears, for example:
The value on the left in the lower line shows the charging current, the value on the right
shows the voltage or number of cells of the battery pack (in this example, a 3-cell LiPo
battery pack,
3 x 3.7 V = 11.1 V).
¼
Select the battery type (LiPo, LiIon, LiFe) as described in chapter 16.
• If the values need to be changed, push the „START/ENTER“ button. The charge current
flashes. Change the charging current using the keys „INC“ and „DEC“ and confirm the
value using the „START/ENTER“ button.
¼
The maximum possible charging current depends on the battery type and number of
cells. Please note the chapter „Technical Data“ at the end of this operating
instruction.
• The voltage then begins to flash. Change this using the buttons „INC“ and „DEC“.
Observe that the voltage is only changed by the number of cells (e.g. one cell = 3.7 V,
two cells = 7.4 V, etc.). Confirm the setting by pressing the ”START/ENTER” button.
• To begin the charging process, keep the „START/ENTER“ button pressed for longer
(approx. 3 seconds).
• If the settings are wrong, or if the charger detects a problem, an audio signal is emitted
and the appropriate information is shown on the display.
LiPo CHARGE
2.0A 11.1V(3S)
Summary of Contents for 23 97 37
