background image

6

12 Status indicators

12.1 Normal

Status indicator

Status

Alternating red/green flashing

Quick start system is ready/starting in progress.

Green steady on

Force start mode is activated.

12.2 Protection mode

Status indicator

Status

Red steady/red flashing

Connection error. Please check all contacts.

Red on/alarm sound on

Reversed polarity: check if the clamps are connected the wrong way
around.

Short-circuit: Both cables are clamped together or clamped to the
same piece of conductive metal.

Red steady on

Reverse charging protection is triggered. Voltage of the connected
battery is >12.6 V.

The jump starter is not needed as the vehicle battery is enough to start
the vehicle.

Red flashing quickly

Over temperature: Clamp >65 (±5) ºC. Remove the clips until the starter
status indicator returns to normal (alternating red/green flashing).

Green flashing slowly

Quick start battery charge is too low, recharge it.

13 Cleaning and care

Important:

– Do not use aggressive cleaning agents, rubbing alcohol or other chemical solutions. They damage

the housing and can cause the product to malfunction.

– Do not immerse the product in water.

1. Disconnect the product from the power supply.

2. Clean the product with a dry, fibre-free cloth.

14 Disposal

This symbol must appear on any electrical and electronic equipment placed on the EU mar-
ket. This symbol indicates that this device should not be disposed of as unsorted municipal
waste at the end of its service life.

Owners of WEEE shall dispose of it separately from unsorted municipal waste. Spent batter-
ies and accumulators, which are not enclosed by the WEEE, as well as lamps that can be re-
moved from the WEEE in a non-destructive manner, must be removed by end users from the
WEEE in a non-destructive manner before it is handed over to a collection point.

Distributors of electrical and electronic equipment are legally obliged to provide free take-back of waste.
Conrad provides the following return options 

free of charge

 (more details on our website):

in our Conrad offices

at the Conrad collection points

at the collection points of public waste management authorities or the collection points set up by man-
ufacturers or distributors within the meaning of the ElektroG

End users are responsible for deleting personal data from the WEEE to be disposed of.

It should be noted that different obligations about the return or recycling of WEEE may apply in countries
outside of Germany.

15 Technical data

15.1 General

Charging input (USB-C

TM

).......................

5 V/DС 2.0 A

Battery pack (rechargeable) ...................

14.8 V 59.2 Wh, Li-ion (non-removeable),16000 mAh

Battery pack (recharge time) ..................

approx. 8 – 9 hours

Protection ...............................................

Short circuit, overload, low voltage, over voltage, overcharge,
over temperature, reverse charging, reverse polarity

Over-discharge protection ......................

≤13 V ±0.3 V

Over-temperature protection ..................

>65 ºC ±5 ºC

Reverse charging protection...................

≥(12.6 V ±0.3 V)

Operating / storage conditions................

-20 to +60 ºC, 40 – 85 % RH (non-condensing)

Dimensions (L x W x H)..........................

207 x 170 x 86 mm

Weight ....................................................

1.5 kg

15.2 Power bank

Charger output (USB-A) .........................

Output 1: 5 V/DC 3 A, 9 V/DC 2 A, 12 V/DC 1.5 A (max. 18 W)

Output 2: 5 V/DC 3 A

15.3 Jump starter

Vehicle on-board system ........................

12 V/DC

Start current (peak value) .......................

600 A (1200 A)

Jump starts .............................................

approx. 15 (affected by factors such as ambient temperature,
size, and mechanical condition of the engine)

Suitable engine types .............................

Gasoline (displacement ≤8.0 L), Diesel (displacement ≤6.0 L)

15.4 Air compressor

Duty cycle ...............................................

8 minutes ON, 5 minutes OFF

Air pressure ............................................

max. 10 bar (150 psi)

15.5 LED light

Light........................................................

White: 4000 K, 200 lm, 2 W

Red: 80 lm, 2 W

Light modes............................................

ON (white) → SOS (white) → ON (red) → Strobe (red)

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).

All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or the capture in
electronic data processing systems) requires prior written approval from the editor. Reprinting, also in part, is prohibited.
This publication reflects the technical status at the time of printing.

Copyright by Conrad Electronic SE.

*2436040_V2_0222_dh_mh_en

pj-id: 9007199626716939-1

i/o: I2/O2

edtl-id: en

Summary of Contents for 2436040













Reviews: