f) Continuity check
Make sure that all the circuit parts, circuits and
components to be measured as well as other
objects of measurement are disconnected from the
voltage.
Select measuring range
To activate the function of the acoustic continuity tester, press the
button „MODE“ (3) twice. Pressing this button again takes you to
the next measuring function (capacity measurement) etc.
- The display indicates the symbol „Continuity
test“.
- A measuring value of less than 100 Ohm is
identified as continuity; in this case a beep
sounds.
- As soon as „OL.“ (overflow) on the display, you
have exceeded the measuring range or the mea-
suring circuit has been interrupted.
g) Capacity measurement
Make sure that all the circuit parts, circuits and
components to be measured as well
as other
objects of measurement are disconnected from the
voltage.
Select measuring range „CAP“
To activate the capacity measurement function, press the button
„MODE“ (3) three times. Pressing this button again takes you to the
next measuring function (resistance) etc.
44
