16
ENERGY METER
4.
The energy cost measuring device is intended for measuring and analysing consumption details of electrical devices. The measuring
device is connected easily between the mains socket and the electric device and requires no additional installation. It is only to be
used with standard domestic mains sockets with a nominal voltage of 230 V/AC. The max. nominal performance must not exceed
3680 watts.
To calculate the costs, the current valid electricity rate can be entered. Further, the device provides a cost forecast per day/month/
year. The consumption details can be displayed and adjusted on the device even when it is unplugged from a power socket. To do
this, the device contains two button cell batteries. The device is only to be used with the specified batteries.
The measuring device is not officially calibrated and therefore must not be used for billing purposes.
Description of the Parts
Protective-earth contact socket with child protection
1.
230 3680
6.20
V
W
W
TO TAL
k W h
1
2
3
4
6
5
7
8
9
SET
Control and setting key
2.
▼
(downwards)
Control and setting key
3.
▲
(upwards)
Display: Display area “Bottom”
4.
Display: Display area “Left”
5.
Display: Display area “Right”
6.
Rear battery compartment
7.
“SET” key for parameter setting
8.
Control and setting key
9.
●
(Confirmation)
Display indications and Symbols
▲
Up symbol
▼
Down symbol
●
Confirmation symbol
SET
Adjustment
MAX
Maximum value display
POWER FACTOR
Display of the power factor CosPhi
TOTAL
Total value
COST
Cost display
TIME
The actual operating time for the electric consumer load, e. g. forfridges.
FORECAST
Calculated cost forecast
DAY
Cost forecast per day
MONTH
Cost forecast per month
YEAR
Cost forecast per year
V
Volt (unit for electric tension)
A
Ampere (unit for electric current)
Hz
Hertz (unit for frequency)
W
Watt (unit for effective power)
COS
Power factor (factor for the phase displacement of V and A)
kWh
Kilowatt hour (unit for the electrical work, consumed power per hour)
Inserting/Replacing the Batteries
Before using for the first time or when the display does not show any values after pressing the button, the coin cell batteries must
be inserted or replaced. The batteries are used to ensure that the set parameters and measured values are saved in the device
even when it is unplugged.
The battery compartment (7) must only be opened if the device is unplugged.
