28
10. STORING / RETRIEVING MEASURED VALUES
You can store up to ten data sets (DATA 0 to DATA 9). A data set consists of four measured values:
• last registered value,
• maximum value (MAX),
• minimum value (MIN) and
• average value (AVG).
Proceed as follows to store and retrieve measured values:
1. When you have finished measuring, press the MEM button (2) while holding down the MEAS
button (6). The values from the current measuring procedure are stored. The display jumps to the
next data set.
2. Release the MEAS button and conduct further measurements as needed.
3. To retrieve stored values, repeatedly press the MEM button until the desired data set appears on
the bottom right of the display (3). The last registered value from the stored measuring process is
shown in the middle of the display.
4. Press the MEM button briefly to toggle between the maximum value, minimum value and
average value. This applies only to values stored in Sequence 1.
Stored values remain in the memory even if you replace the battery.
You can overwrite old values by selecting any memory cell, conducting measurements and
storing the values following the above steps.
There are no maximum/minimum/average values for the functions from Sequence 2 (REV, M,
In, FT and Yd).
11. ATTACHING THE CASE HANDLE
On the sides of the case lock, there are two holes for attaching the case handle. There are two
inward-pointing pegs on the case handle. Proceed as follows to attach the handle:
1. Insert one peg into one of the holes.
2. Carefully stretch the handle and then insert the second peg into the other hole.
3. To remove the handle, proceed in reverse order.
Summary of Contents for DT-30LK
Page 59: ...59...
