3.Functions and Operations
19
Press the Threshold softkey to set the short-circuit resistance.
Press
to move the cursor, press
to increase or decrease the value.The
range for the 0 Ω to 1000 Ω. The default is 50 Ω.
5. Continuity measurements behave as follows:
Circuit resistance to be measured
Display and beep
≤ Short-circuit resistance
Displays measured resistance and beeps (if
beeper enabled)
Short-circuit resistance to 1000Ω
Displays measured resistance without
beeping
> 1000Ω
Displays "Open" with no beep
Diode Test
This section describes how to configure diode test.
Operating Steps:
1. Enable the diode test.
Press
on the front panel, press it twice to enter diode test mode.
2. Connect the test lead.
3. Set the beeper.
Press the Beeper softkey to enable or disable the beeper. When the beeper is
enabled, the diode is connected, the multimeter will beep continuously.
4. Diode measurements behave as follows:
Forward pressure
drop of diode
Display and beep
0 to 3 V
Displays measured voltage, and the multimeter beeps
when the voltage is below 0.7 V (if beeper enabled)
