53
c) MAX/MIN function
This feature allows you to save and display the maximum and minimum value for a series of measurements.
Automatic range selection will be disabled. It is necessary that you manually set the range.
This feature is only available in some modes.
• Press the MAX/MIN button (13) to enable this feature.
• The maximum and minimum readings for the current set of measurements will be saved.
• Press the MAX/MIN button to switch between the maximum and minimum readings.
• The readings will be deleted when you switch to another measuring mode or turn off the multimeter.
• To disable this feature, hold down the MAX/MIN button for 2 seconds. [ MAX ] or [ MIN ] will disappear from the
display and [ AUTO ] will be displayed.
d) REL function
The REL function sets a reference value in order to discount test lead interference during resistance measurements.
The displayed reading will be reset to zero when the reference value has been set.
Automatic range selection will be disabled. It is necessary that you manually set the range.
This feature is only available in some modes.
• Press the REL/ZERO button to activate this mode. The [ ] symbol will appear on the display.
• To disable this feature, press the REL/ZERO button again or change the measuring mode.
e) HOLD function
This feature freezes the current reading on the display so that you can record it for future reference.
When testing live wires, make sure that this feature is disabled before you take any measurements,
otherwise the reading will be incorrect.
This feature is only available in some modes.
• Press the button (17) to enable this feature. The multimeter will beep and [ ] will be displayed.
• To disable the hold feature, press the button or change the measuring mode.
