Q
UICK
S
TART
Power Analyzer User Manual
© Voltech 2010
Page 13
The simplest and safest way to make a connection to the
product under test is to use a Voltech Break Out Box. This
provides a line socket for connection of the product and 4 x
4mm sockets for direct connection to the
terminals as described above.
2.3.
D
EFAULT
M
EASUREMENTS
Switch on the supply to the load and the is now ready to make
measurements. Note that it is not necessary to switch the either off or on
when the load is being connected.
The default display shows 4 values. Each line clearly shows the measurement type
„Vrms‟, the measured value, „248.4‟ and the measurement units, „V‟. Normal
engineering notation is used to describe units, e.g. mV = milli-volts (10
-3
) and MV =
mega-watts (10
+3
).
To scroll through the measurements, use the 4 keys to the right of the display:
Jump Up
Display the page above.
Up
Move up through the measurement list.
Down
Move down through the measurement list.
Jump Down
Display the page below.
