G
ETTING
S
TARTED
IEC61000-3
S
OFTWARE FOR
W
INDOWS
U
SER
M
ANUAL
Page 42
VPN 98-025/7
Voltech Instruments
If the power factor is unknown, it will be measured by the analyzer and this
value can be entered retrospectively at the end of the tests and the limits re-
computed accordingly.
4.8.
P
ERFORMING A
H
ARMONICS
T
EST
Once the test has been configured, choose 'Fluctuating Harmonics' from the
'Run Test' menu:
and the software will automatically configure the analyzer and AC Source.
(For a manual source, you will be prompted to 'Switch the Mains on Now'.
Once the system is ready, you will see the following dialogue:
Click on 'Start' to begin the test.
In accordance with the standards, the first 10 seconds of the test will be
ignored. The equipment under test should be switched on or - depending on
the equipment behaviour- before the time that you click start.
Summary of Contents for PM3000ACE
Page 4: ......