Volth S-NET1, Operation Manual

Ports on Remote identifier

(1) RJ45: remote testing cable continuity for Lan cable. 
(2) Port RJ11: remote testing cable continuity for telephone cable.
(3) Port BNC: remote testing cable continuity for COAX cable. Ports 

Instruction on Main interface

Here are seven main functions on Main interface.

(1) Mapping --- Test cable continuity, such as the cable is good, open, short, cross, reverse 
     connection, etc.
(2) Port flash---locate network cable visually by the flashing port light on Hub / Switch. 
(3) Scan--- find the targeted cable among unknown cables, also roughly locate short position 

     by tone.

(4) PING---to test network performance, data packet, min & max time. 
(5) Length--- measure cable length and also display cable errors' distance. 
(6) PoE--- identify which pins are providing power and also detect how much voltage 
(7) Set---Set up backlight/ backlight time/ auto-off time/ theme color/data export/system           
     information (version No.),ect. 

Charging function

          The power supply for main tester and receiver are both 3.7V Rechargeable battery, its 
capacity is 1800mAh. When finish charging, the main tester can work continuously for over 
20hs, receiver can work for over 50hs. The rechargeable battery avoids the trouble of 
replacing 9V battery again and again. The whole standard charging devices are included. After 
charging, please disconnect the charging device, otherwise it would shorten the battery life.

W

IR

E

M

A

P

Remote identifier 

Menu

Mapping

Port Flash

POE

Scan

Length

Ping

Menu

Set

S-NET1