Voltima - Jumpstarter
39
Instructions for jump starting
Check that the battery voltage is 12V before jump starting (not for 24V or 6V suitable). If the voltage
is below 4.5V or above 14.1V, jump starting is not possible.
1.
Check the polarity of the battery terminals.
2.
Follow the vehicle manufacturer's instructions.
3.
Remove the insulating cover from the battery terminals.
4.
Connect the red positive (+) terminal to the positive terminal of the car battery.
5.
Connect the black negative terminal (-) to the negative terminal of the car battery.
6.
Always connect the connecting cables to the car battery before starting the car.
7.
Switch off ALL electronic devices in your vehicle to ensure the best performance from
your jump starter.
8.
Make sure the key is in the "OFF" position in the ignition lock.
9.
For "push-to-start" vehicles, make sure the vehicle is completely "OFF" before jump
starting.
Achtung!
When using this unit to jump start, make sure that the positive and negative terminals are
connected correctly. If this is not the case, the battery may explode.
Summary of Contents for VJS Series
