User manual - ARTI 130-2 + T5 Mini + HV640
202008-481A-ENG
P12
4. USE OF THE MACHINE
4.1. PREREQUISITES
•
The electric connection has to be 230 V - 16 A - 50 or 60 Hz.
•
Be careful to only use paints which have not dried and which do not contain dry particles (otherwise,
filter the paint with a strainer).
• When using a chlorinated product, it is imperative to dilute the product (5% of pure product maximum).
•
Before use, verify the air filter foam (V). Replace it if it is used or missing by loosening the plastic cover.
•
Choose the ideal needle kit depending on the paint which will be used. To change the nozzle, loosen
the ring (K).
•
The turbine is equipped with a thermal circuit breaker (T) which stops the motor when it reaches a
temperature which is too high. If the turbine fuse has blown, verify that the electrical connection is
correct and that the filters (H) and (V) are not clogged up, then press the (T) button to reset the circuit
breaker.
• The set can be used to spray bactericidal products (bleach, etc.). In this case it is imperative to respect
the following rules:
•
Use the appropriate PPE to avoid any contact of the product with the skin, eyes and respiratory tract.
• Do not spray in the presence of people or animals.
• Wait for objects and surfaces to dry completely before handling.
• Absolutely respect the manufacturer’s recommendations for use (dilution, handling, etc.).
•
The product must always be diluted before filling the bowl (maximum concentration of pure
product 5%).
• Never spray pure products.
•
Once the work is finished, rinse the bowl and gun thoroughly with water to avoid damage to the
metal parts.
The spraying of potentially dangerous products remains the sole responsibility of the users.
Choice of the atomization kit
•
The spray-gun can be equipped with 6 different jet nozzles.
•
Choosing the right atomization kit is essential to obtain a perfect finish. This choice has to be made
according to the work to be done, the kind of paint, the dimensions of the objects and surfaces to be
covered (see table below).
Nozzle Ø
Work to be made
Viscosity
Product to be used
0,80 mm
Finishing jobs, low output, small areas,
decoration, refinishing, shadow, stain, etc...
15 seconds
Light, thin, chromate products, etc...
1,30 mm
All kind of varnish jobs, house-hold
appliances, furniture, car bodywork,
aviation, etc...
26 seconds
All products with normal dilution, lac-
quer, varnish, oil based, cellulosic, polyu-
rethane, etc...
1,80 mm
For usual jobs, high output, large areas
+30
seconds
Bottom layer, primer, oil based paints,
dispersion, etc...
2,20 mm
Thick layer, high output, large areas,
speckled, decorative ef-fects, building,
insulation, etc...
Glues, heavy products, minium, gelcoat,
oilbased varnish, etc...
2,40 mm
2,60 mm
Before each use, atomize some water before using the paint to be sprayed.
Too high a concentration of chlorinated product can lead to corrosion of the gun.
