37
111. Fit tool 999 5021 and depress the camshaft.
112. Lubricate the camshaft seal’s rubber lip and fit it
on the camshaft. Be careful so that the rubber lip
is not damaged by the sharp edge when fitting it.
Fit the sealing ring so that a new wear surface
against the camshaft is obtained.
113. Oil and lay the other three bearing caps in posi-
tion and fit the nuts for the four bearing caps.
Tighten them somewhat NOTE! The forward
bearing cap’s surface against the cylinder head
is to be painted with sealing fluid before it is
fitted. Make sure that the seals fit correctly before
the front bearing cap is tightened. Then remove
the tool.
114. Oil and fit the last bearing cap. Then tighten all
the nuts with a torque wrench. The tightening tor-
que is 20 Nm (2.0 kpm) (14.7 lbf. ft.).
Summary of Contents for AQ125A
Page 1: ...Workshop Manual Engine Unit AQ125A B AQ145A B C 2 0 ...
Page 2: ......
Page 74: ...7739856 8 English 11 1998 ...