FUEL FULL tanK CaLiBration
notE!
A FUEL FULL TANK CALIBRATION requires
that FUEL TANK EMPTY has been set.
When FUEL FULL TANK CALIBRATION is selected,
the fuel level sender is calibrated in one step. This
only gives an approximated value of the fuel level.
Therefore all trip data concerning and based on,
remaining fuel volume should be recognized as ap-
proximated values only.
1.
Activate helm station by pushing the ACTIVA-
TION BUTTON
.
2. Select SETTINGS from MAIN MENU by turning
NAVIGATION WHEEL. Push NAVIGATION WHE-
EL to enter SETTINGS MENU.
3. Select FUEL TANK CALIBRATION and push NA-
VIGATION WHEEL.
4. Select FULL TANK CALIBRATION by turning NA-
VIGATION WHEEL. Push NAVIGATION WHEEL
to enter FULL TANK CALIBRATION.
5. Fill fuel tank and push NAVIGATION WHEEL.
Push BACK BUTTON to return to SETTINGS MENU.
Fuel alarm pop-up
The fuel level alarm pop-up will appear when the fuel
level is lower than fuel alarm setpoint. The pop-up
shows the percentage of fuel remaining.
Acknowledge fuel alarm by pushing NAVIGATION
WHEEL.
Fuel level alarm pop-up will re-appear every 10
minutes until the fuel level in tank is higher than fuel
alarm setpoint.
Fuel level signal loss
If the fuel level has been set and the fuel level signal
is lost, for instance in the case of sensor malfunction,
the fuel level alarm signal loss pop-up will appear.
approximated trip data
This pop-up will be shown every time after start-up if
start-up ifif
FUEL FULL TANK CALIBRATION is performed.
27
Instruments
Summary of Contents for D9 MH
