Faults are stored and malfunctions have
been registered
Faults list
A faults list can be viewed from the MAIN MENU, if a
fault is registered.
When in MAIN MENU, select FAULTS by pushing
NAVIGATION WHEEL. Number after FAULTS indica-
tes number of faults stored in faults list. Show faults in
faults list by turning NAVIGATION WHEEL.
Shown fault pop-ups will alternate between “cause of
fault” and “measures to take”.
More information regarding “cause of fault” and “mea-
sures to take” is found in chapter “Fault register”.
Erasing faults in faults list
Any fault pop-up in the diagnostic function are auto-
matically erased every time the starter key is turned
to the stop position (S).
notE
! Stop the engine and check that the ignition
key(s) is(are) in position 0 in all control positions.
When system voltage is switched on again, the diag-
nostic function checks to see whether there are any
faults in the EVC system. If this is the case, new fault
pop-ups are shown.
This means that:
1. Faults which have been attended to or have dis-
appeared are automatically erased.
2. Faults which have not been attended to must be
acknowledged every time the system voltage is
switched on.
89
In case of emergency
Summary of Contents for D9 MH
