Volvo Penta TAD1240GE Operator'S Manual Download

Page: 8 / 76

Introduction

This instruction book has been compiled to give you the best possible use of your Volvo Penta industrial engine.
It contains the information you need to operate and take care of the engine in a safe and correct manner. We the-
refore ask you to read the instruction book carefully and to learn to handle the engine, controls and additional
equipment in a safe manner before you start the engine.

IMPORTANT!

The instruction book describes the engine and equipment that are sold by Volvo Penta. In

certain applications there can be variations of for example controls and instrumentation that concern both
appearance and function. In these cases we refer you to the instruction book for the application in question.

Environmental care

We all want to live in a pure and healthy environment
where we can breathe fresh air, see healthy trees,
have clean water in our lakes and oceans and where
we can enjoy the sunshine without fearing for our
health. Unfortunately this is not always the case today
but it is a situation that we all must work to preserve
and protect.

As an engine manufacturer Volvo Penta has a special
responsibility, therefore care for the environment is a
core value in our product development. Today Volvo
Penta has a broad engine line where large steps have
been taken towards reducing exhaust emissions and
improving fuel economy, engine noise and so on.

We hope that you will be careful to preserve these
qualities. Always follow the advice in the instruction
book regarding fuel quality, operation and maintenan-
ce so that you can avoid unnecessary damage to the
environment. Contact your Volvo Penta dealer if you
notice changes such as decreased fuel economy or
increased exhaust smoke.

Remember to always bring hazardous waste such as
drained oil, coolant, used batteries etc. to an environ-
mental station for destruction.

Through our mutual efforts we can make a valuable
contribution to the environment.

Running-in

The engine should be ”run-in” during the first
10 hours of operation according to the following:

Run the engine as with normal operation. Full-throttle
operation should not occur for more than short peri-
ods. Do not run the engine for long periods of time at
steady RPM during the run-in period.

An increase in the consumption of lubricating oil is
normal during the first 100–200 hours of operation. It
is therefore important to check the oil level more often
that is normally recommended.

When a clutch is mounted it should be inspected more
frequently during the first days of operation. Adjust-
ment may be required to compensate for initial wear of
the plates.

Fuel and oils

Only use fuel and oils of a grade matching that recom-
mended in the instruction book (see the chapter on
”Maintenance” under the fuel and lubricating system
headings). Other grades can cause problems with
operation, decreased fuel economy and in the long run
even a shortened lifetime of the engine.

Always change the oil, oil and fuel filters according to
the prescribed intervals.

Maintenance and replacement
parts

Volvo Penta engines are constructed for maximal de-
pendability and longevity. They are built to survive in
demanding environments but also to have the mini-
mum possible impact on the environment within which
they operate. Regular maintenance and use of Volvo
Penta original parts will preserve these properties.

Volvo Penta has a worldwide network of authorized
dealers. They are specialists on Volvo Penta products
and have accessories, original parts, test equipment
and the special tools that are necessary for high-quali-
ty service and repair work.

Always adhere to the maintenance schedules lis-
ted in the instruction book and remember to prov-
ide the engine/transmission identification number
when ordering service and parts