14
CIU
CIU
General
The installation must be well prerared and performed
with great care.
Secure the connecting cable between motor and in-
strument panel with clamps. Remember that the strain
on the coupling pieces must be relieved so that they
are not subjected to any pull.
Cables must not be run too close to hot components
on the engine or close to any other source of heat.
Make sure that it is protected from mechanical wear,
sharp edges and water splashes. If necessary, run the
cable through protective conduits.
Avoid making joints in the system as far as possible.
Cables and any joints must be accessible for inspec-
tion and service.
NOTE!
The connectors must be installed “dry”, they
must not be packed with Vaseline etc.
Connecting cable
Connecting, see section
Instruments
Extension cables are available in the follo-
wing lengths: 3, 5, 7, 9 and 11 m
8-pin Deutsch
connector from
cable harness on
engine
3-pin Deutsch connec-
tor, Easy Link instru-
ments
Connectors, analogue
i n s t r u m e n t s
(optional)
8-pin Deutsch
connectors
Summary of Contents for TAD734GE
