immediately by turning the ignition switch to the OFF position
(0).
If a red warning lamp lights up and/or the buzzer sounds, stop
the engine immediately and investigate the cause.
In case of fire, the battery disconnect switch should be turned
off if possible.
W
W
h
h
i
i
l
l
e
e
wo
o
r
r
k
k
in
n
g
g
,
,
do
o
no
o
t
t
:
:
swing the bucket or load above people.
use the bucket or other attachment for chopping.
extend the hydraulic cylinder to its end of stroke. This can
overload the stop in the cylinder and shorten the life span of
the machine. Work with as much clearance as possible.
operate closer than 10 cm (4 in) from the hydraulic cylinders
end-of-stroke positions when using equipment which generate
knocks or vibrations, e.g. hammer.
use the swing force for raking over the ground, demolition of
buildings or thrusting bucket teeth into the ground. It may cause
damage to the machine and attachments.
work by slamming the bucket into the ground. Do not perform
digging by dropping the boom, or using the bucket instead of a
pick. Striking digging or continuous striking can overload the
rear of the machine or damage the attachment. It is also very
dangerous.
carry out lifting work. Basically, using this machine as a crane
is prohibited. However, local or national regulations may allow
it on some markets. If permitted, a properly installed rated
bucked hook and certified slings / shackles are required.
Contact an authorised dealer for more information.
Lo
o
a
a
d
d
i
i
ng
g
on
n
to a veh
h
i
i
cle
If possible, position the machine higher than the vehicle to be
loaded.
Place the vehicle to be loaded so that the machine does not
have to swing and lift more than necessary.
Make sure that the operator of the vehicle to be loaded stays
outside the working area of the machine and never swing the
bucket over the cab of the vehicle to be loaded.
Do not load the vehicle unevenly and avoid unnecessary
spillage when loading. Do not make the load so high that earth
and stones fall over the platform sides.
Place large stones on a layer of finer material at the rear of the
platform, so that the platform is not damaged when dumping
the load.
Release the load carefully.
WA
A
R
R
N
N
I
I
N
N
G
G
Risk of crushing.
Material may fall off when loading a vehicle.
Make sur
r
e th
h
at no
o
pe
e
r
r
sons are sta
a
nd
d
i
i
ng ne
e
a
a
r
r
th
h
e
e
veh
h
i
i
cle wh
h
il
l
e
lo
o
a
a
di
i
n
n
g
g
.
.
V1086030
19
9
6
6
Op
p
e
e
r
r
a
a
t
t
i
i
n
n
g
g
te
e
c
c
hn
n
i
i
q
q
u
u
e
e
s
s
Ru
u
l
l
e
e
s
s
fo
o
r
r
di
i
g
g
g
g
i
i
n
n
g
g
Summary of Contents for 322001
