44
Preparation for storage
•
For periods of storage up to 8 months:
Change the engine oil and oil filter and then run
until warm.
For periods of storage longer than 8 months:
Preserve the lubrication and fuel systems with
preservation oil. See instructions on next page.
•
Make sure that the coolant’s freeze protection is
sufficient. Supplement as needed. As an
alternative the coolant can be drained (drain also
the coolant filter).
•
Drain off any water and contamination from the
fuel filter and the fuel tank. Fill the tank
completely full with fuel to avoid building of
condensation.
•
Disconnect the battery cables and clean and
charge the batteries. Maintenance charge the
batteries periodically during the storage period. A
poorly charged battery can freeze and break.
•
Clean the engine externally. Do not use high-
pressure spray when cleaning the engine. Touch-
up paint damage using Volvo Penta original paint.
•
Spray the electrical system’s components with a
water displacing spray.
•
Check and treat control cables using rust-
preventative.
•
Affix a note on the engine showing the date, type
of preservation and type of preservation oil is
provided.
•
Cover the air filter, exhaust pipe and the engine if
called for.
To prevent the engine and other equipment from suffering damage during periods of storage exceeding two
months a preservation procedure should be performed. It is important that this be done correctly and that no part
of it be forgotten. We have therefore created a checklist covering the most important points.
Before the engine is taken out of service for an extended period an authorized Volvo Penta service facility should
perform a check.
Problems should be addressed at this point so that the equipment will be ready for use when needed next.
WARNING! Prior to starting maintenance work the chapter ”Maintenance” should be read carefully. In it you
will find instructions for how the work can be carried out in a safe and correct manner
WARNING! Certain preservation oils are flammable. Some even produce dangerous fumes. Make sure that
there is good ventilation. Use a protective mask when spraying.
IMPORTANT! When cleaning with a high-pressure sprayer the following instructions must be kept in mind:
Never point the spray at seals, rubber hoses or electric components. Never use the high-pressure function
while cleaning the engine.
Preparation for storage
Summary of Contents for TAD1240GE
