7
4
CABLE INSTALLATION
4a
Insert cable end fitting(s) into center slide.
Be sure to attach top cable to top end of center slide
(marked “This Side Up”)
a-4
a-5
⁵⁄₃₂
"
hex
wrench
a-2
a-3
Remove tape from door edge, then repeat
process to install bottom cable into bottom spool.
For 2-Point Latch Only
a-6
a-1
Pull top cable thru mortise
opening (a-1).
Rotate spool using hex
wrench to reveal cable hole
in spool (a-2), if it is not
visible or only partially
visible.
Insert cable end into spool
(a-3).
Turn
spool screw
clockwise
(a-4) to rotate spool until
cable end is beneath profile
of center slide (a-5).
Marked "This Side Up"
4b
Take up top cable slack only.
⁵⁄₃₂
"
hex wrench
Position center slide as shown. Turn
top
spool screw
clockwise to tighten (b-1)
until center slide is no longer hanging
outside door.
NOTE:
If clicking noises are heard
during clockwise adjustment, unwind
the cable with one-half turn counter-
clockwise. Then, continue clockwise
adjustment. If clicking persists, check to
be sure cable is not caught on an edge.
!
Center slide
is resting on
step of door
pocket
b-1
Do not adjust
bottom cable
at this time.
!
4c
Secure center slide.
¹⁄₈
" Drill, Pilot 1" Deep x2
#8
x
1
"
4d
Adjust top spool.
Turn
top spool screw
(d-2) until pin is
centered to the line (d-3).
Put top latch in locked
position (d-1).
NOTE:
Top latch must be placed
in locked position prior to making
top adjustment.
!
Released
Locked
NOTE:
No further top spool adjustment needed.
Put hex wrench away until Step 8b.
!
Confirm top latch is
still locked (d-4).
Locked
d-1
d-4
d-2
pin
d-3
If latch won’t lock,
top spool screw
was overtightened
in Step 4b and
needs to be
backed out
counter-clockwise.
!
