3
4
Temporarily Attach Bottom Latch Cable Assembly
to Center Slide.
For 2-Point Latch Only
6
Adjust Bottom Latch Retraction (if necessary).
For 2-Point Latch Only
d. While holding the snap-fitting
with a
³⁄₈
" wrench, continue to
tighten the locknut until it is
secure.
c. While holding the conduit cap
with a
³⁄₈
" wrench, use a 10mm
wrench to turn the locknut in a
clockwise direction to close the
gap between the lock nut and
snap-fitting. Stop when the gap
is closed and the snap-fitting
begins to turn with the locknut.
a. While holding the snap-fitting
with a
³⁄₈
" wrench, use a 10mm
wrench to break loose the lock
nut.
b. While holding the lock nut in
place, rotate the barrel of the
snap-fitting clockwise by hand
until the bottom latch is
retracted to within
¹⁄₁₆
" of flush.
bottom latch
(retracted)
¹⁄₁₆
"
flush
snap-fitting
locknut
conduit cap
NOTE
: Adjustment must be made while the top
latch is in the hold-open position, with cable
flexed into an L-shape to simulate the installed
condition of the latches.
!
These (3) hex
components
are used to
make the
adjustment.
5
Determine if Bottom Latch Retraction Adjustment is
Necessary.
For 2-Point Latch Only
a. Flex the cable into an L-shape as shown to simulate the installed
condition of the latches.
top latch
(hold-open
position)
bottom latch
(retracted)
¹⁄₁₆
"
flush
press
b. To determine whether an adjustment is required, actuate the top
latch to the hold-open position by pressing down on the connecting
rod. Bottom latch should retract to within
¹⁄₁₆
" of flush. If it does not,
an adjustment is necessary.
If no adjustment is needed,
proceed to Step 7.
bottom latch
lock nut
10mm
³⁄₈
"
10mm
³⁄₈
"
conduit
cap
³⁄₈
"
10mm
snap-fitting
Position
Cable C
to
bottom mounting
bracket on center slide
Push cable snap
against mounting
bracket to secure
cable
Pull on cable end to
attach it to the cable
link
a
b
c