8
How to adjust the pattern
1. Make sure that the paint sprayer is turned off.
2. Loosen the retaining nut by turning it anti-
clockwise.
3. Adjust the position of the multiposition
regulator to produce the vertical, horizontal or
precision patterns.
4. Tighten the retaining nut.
IMPORTANT: DO NOT fire the gun without
adjusting the retaining nut.
INTENSITY ADJUSTMENT
The intensity adjustment will allow you to
increase or decrease the flow of paint that
comes out of the nozzle. Turn the flow adjusting
nut clockwise to tighten it and obtain a greater
flow of paint, or turn it anticlockwise so
that the output pressure of the paint is less.
INSTRUCTIONS FOR USE
If painting with a paint sprayer system is
something new or unknown to you, it is
recommended that you practice on a wood or
cardboard surface before starting to work on the
desired surface.
IMPORTANT:All objects and surfaces you want to
paint should be cleaned before being sprayed.
All areas that you do NOT want to paint should
be covered.
How to spray
•
Firstly carry out a spray test and adjust the
spray pattern and the amount of material to
spray according to the latter.
•
Make sure you hold the spray in a vertical
position and parallel to the area of application,
at a distance of 25 to 30 cm.
•
Always start to spray outside the desired area
to load the trigger.
•
Move the spray gun uniformly, crossing from
top to bottom, or from one side to the other,
depending on the spray pattern.
NOTE: For a uniform spray, keep your wrist
straight and parallel to the surface. If you bend
your wrist or arm while painting, the angle
of spraying could cause a splodge of paint in
certain areas, which will leave an uneven finish.
Vertical mode: makes a
side to side movement.
Horizontal mode: makes
an upward and downward
movement.
Precision point mode for
detailing.
VERTICAL PATTERN
HORIZONTAL PATTERN
PRECISION POINT
