Be careful when insering the micro connector to the micro expansion board. With connecting
cable side facing down, conenct the connector to the board as per below. In case of damaging
the pieces, do ont force to connect the pieces.
Insert the connectors to the ports.
Be careful when you are operating, there’s only one correct way to insert, make sure the
expansion board is upward, find the soldered “=” sign on the left of the port. When you
are inserting, the side which the wires can be seen should be faced to the “=” sign and
if you feel hard to insert, please stop, and don’t force it, for that may result in bent
pins inside the port or overheating of the expansion board.
At this point, use the tweezers to straighten the bent pins.
Summary of Contents for 10273
Page 4: ......
