Unit
：
50.0 pF/m
：
1-2
EasyCheck 900 User Guide
Cable Test
12345678
R1 12345678
Split
：
1236
7.3
Length Test
The length test function measures the length of a cable by measuring its capacitance,
it is supported in one-end test mode. The capacitance per unit length can be adjusted.
When testing an unterminated cable it is possible to use the RJ45 to Alligator clip cable,
and set the pair to
“
1-2
”
.
The
EasyCheck 900 automatically runs a new test every
second. The LCD displays is shown below:
Length Test
Unit
：
49.0pF/m
Pair
：
1-2
Test
Result
Len
：
1.5m
Press[
↑
] or [
↓
] to adjust the capacitance per unit length, and the EasyCheck 900 will
display as follows
：
Length Test
Pair
50.0
Len
：
1.5m
For cables of unknown capacitance per unit length, a cable of known length of the
same type may be used as a reference. The Unit value may then be adjusted to give
the correct result on the reference cable before performing a test on the cable to be
measured. To improve the accuracy of your reference setting, it is better to use a
reference cable greater than 20 meters.
Press [OK] repeatedly to select a wire pair to be tested, See the display below.
7-7
