MyIP
：
8
2
.
EasyCheck 900 User Guide
Flash link LED
Link found.
Flashing!
7.6
Ping Test
Ping test is for testing the network connectivity using the ICMP protocol. Before IP
testing, the IP address and the target IP address of the EasyCheck 900 must be set
first. If these two address are not in the same LAN , the gateway and subnet mask
should be set, too.
7.6.1
Quick Setup
To configure the Ping Test using static IP addresses the following steps must be
followed.
Press [OK] to select the EasyCheck 900
‟
s
IP
with the selected value highlighted;
Press [
ç
] or [
è
] to go to the number of the IP address to be modified and press [
é
]
or [
ê
] to change the value;
Press [OK] key again
，
and select the target IP;
Set the target IP Address in the same way, press [OK] to escape and start a ping test.
Example
：
The following diagram shows modifying the last value of the EasyCheck
900
‟
s
IP
Address:
EasyCheck
Ping Test
900
‟
s
IP
Target IP
My
：
192.168.001.00
8
Ta
：
192.168.001.010
Ping
…
7.6.2
Complete Setup
In the Ping test mode
，
press[SETUP] key to enter the Ping Setup screen, in which you
may modify values of My
IP(tester
‟
s
IP),
Target
IP
，
Gateway and Subnet Mask and
view the MAC physical address of the EasyCheck 900.
Ping Set
19
1
.168.001.008
7-9
MyIP
