If you are having difficulty using this product and require support,
please contact
hello@domu.co.uk
PROBLEM
SOLUTION
THE TOOL WILL NOT START
SANDING SLEEVE DOES NOT ROTATE
WITH RUBBER DRUM
LARGE AMOUNTS OF DUST IS BEING PRODUCED
CORROSION IS FORMING ON THE TABLE TOP (4)
SANDING DRUM NOT OPERATING AT FULL SPEED
OR MOTOR SOUNDS DIFFERENT TO NORMAL
Ensure the tool is connected to mains
power.
Activate the ON/OFF Switch.
Check the fuse and replace if required.
Spindle Lock Nut (6) is not tight enough.
Tighten Spindle Lock Nut in small
increments until the Rubber Drum secures
the Sanding Sleeve.
Dust extractor passage is blocked.
Turn off the machine at the mains. Remove
the Rubber Drum, Table Insert
(10)
and the
Spindle Washer
(9)
. Remove the blockage
from the dust extractor passage
Incorrect Table Insert used.
Change to the correct-sized Table Insert
Moisture is causing the Table Top to
corrode.
Using a clean dry cloth, rub a thin film of
compatible protective lubrication over the
clean Table Top surface.
Motor over-heating.
Switch off and allow to cool for a 1/2hr.
Motor faulty.
Contact DOMU Customer Service.
TROUBLESHOOTING
