A5P | 01
Machine slows when operating.
1. Feed rate too great.
1. Reduce the rate at which the
workpiece is fed onto
belt or disc.
2. Undersized circuit or use of under-
sized extension
cord.
2. Ensure circuit wires or extension
cords are proper
gauge, or eliminate use of extension
cords.
Machine vibrates excessively.
1. Incorrect motor mounting.
1.
Tighten/strengthen motor mount
-
ings
2. Incorrect sanding-belt tension.
2. Adjust tension adjustment knob.
Follow
belt-tensioning/tracking instructions
in this manual.
3. Weak or broken tension spring.
3. Have tension spring replaced by
service technician.
4.
Broken/defective sanding accesso
-
ries.
4.
Replace sanding belt/disc.
Workpiece frequently gets pulled
out or operators hand.
1. Not supporting the workpiece
against the stop.
1. Use the platen (backstop) or mitre
gauge to support
the workpiece.
2. Attempting to sand (unaided) a
workpiece that is too small.
2. Use another hand tool or jig to
grasp or hold the workpiece.
Workpiece lifts up from the
sanding disc/table.
1.
Sanding on the “up” side of the
wheel.
1. Sand on left hand side of sanding
disc (as operator
faces the disc).
PROBLEM
CAUSE
SOLUTION
Summary of Contents for 3500181
