VONROC PH504XX, Original Instructions Manual

EN

5

WWW.VONROC.COM

4.  Upper pole locking knob
5.  Safety pin
6.  Lower pole
7.  Leg adjustment knob
8. Leg
9. Feet
10. Brace
11. Screw

3. ASSEMBLY

Always mount the device with the supplied 
accessories.

Do not overtighten any of the locking or 
adjustment knobs. This will result in indue 
stress to the fitting.

Always secure the stand with the safety pin 
(5).

Before starting the installation, take the following 
into consideration:
•  Place the device on a firm, level surface.
•   The device must be mounted so that there is 50 

cm of free space between the heater and any 
ceiling, tent canvas etc. The device may never 
be hung at an angle!

•   Ensure that the power supply cable is well 

mounted and that it does not come into contact 
with reflector of the heater or that does not trail 
into heated area.

•   Do not install the heater near an inflammable 

surface.

•   If the heater is to be used outside, a weatherp-

roof outlet is highly recommended.

Setting up the stand (Fig. A)

1.  Loosen the leg adjustment knob (7).
2.   Spread legs (8) apart to max. base width. 

Extend until the braces (10) are in a horizontal 
position, as shown on figure A. This ensures 
maximum stability and loading capacity.

3.  Tighten the leg adjustment knob (7).
4.   Loosen the upper pole locking knob (4) and 

remove the safety pin (5).

5.   Lift the upper pole (3) to the desired height. Put 

the safety pin (5) in the corresponding hole (in 
the upper pole) of the selected height.

6.  Now tighten the upper pole locking knob (4).

Collapsing the stand (fig. A, E)

Pay attention to possible hazards (squee-
zing, hurting) by collapsing

1.   Whilst holding the upper pole (3), loosen the 

upper pole locking knob (4) and remove the 
safety pin (5).

2.  Lower the upper pole (3).
3.  Loosen the leg adjustment knob (7).
4.   Fold in legs (8) to fully collapsed position, as 

shown on figure E.

Assembling the heater onto the stand 
(Fig. A, B, C, D)

1.   Using the screws (11), mount the 2 mounting 

brackets (1) onto the holes of the heater, as 
shown on figure B.

2.  

Put the heater with the assembled brackets on 
the top of the heater stand, as shown on figure C.

3.   Whilst holding the heater, assemble and tighten 

the angle adjustment knob (2) as shown on 
figure C.

4.   Figure D shows a correctly assembled mounting 

bracket assembly.

4. OPERATION

Do not overtighten any of the locking or 
adjustment knobs. This will result in indue 
stress to the fitting.

Always secure the stand with the safety pin 
(5).

Adjusting the height with assembled heater (Fig. A)

Note: for optimal safety, this may be performed by 
two persons.

1.   Whilst holding the heater, loosen the upper pole 

locking knob (4) and remove the safety pin (5).

2.   Move the upper pole (3) to the desired height. 

Put the safety pin (5) in the corresponding hole 
(in the upper pole) of the selected height.

3.   Now release the heater and tighten the upper 

pole locking knob (4).

5. MAINTENANCE

Handle the stand with care. Inspect bolted assem-
blies regularly. Maintain only in unloaded mode.