8
EN
WWW.VONROC.COM
7. Reload lever
8. LED work light switch
9. Safety tip
10. Belt hook
11. Adjustment knob
12. Battery LED indicators button
13. Battery LED indicators
14. Charger
15. Charger LED indicators
3. ASSEMBLY
Before any work on the power tool, remove
the battery.
The battery must be charged before first
use.
Inserting the battery into the machine (Fig. B)
Ensure that the exterior of the battery is
clean and dry before connecting it to the
charger or machine.
1. Insert the battery (2) into the base of the
machine as shown in Fig. B.
2. Push the battery forward until it clicks into place.
Removing the battery from the machine (Fig. B)
1. Push the battery unlock button (3).
2. Pull the battery out of the machine like shown
in Fig. B.
Checking the battery charging status (Fig. C)
• To check the battery charge status, push the
button (12) on battery shortly.
• The battery has 3 lights indicating the charge
level, the more lights that burn, the more
charge the battery has left.
• When the lights are not burning it means
the battery is empty and must be charged
immediately.
Charging the battery with the charger (Fig. C)
1. Take the battery (2) from the machine.
2. Turn the battery (2) to upside down position and
slide it onto the charger (14) as shown in Fig. C.
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet and
wait for a while. The LED indicators on the charger
(15) will lighten up and show the charger status.
The charger has 2 LED indicators (15) which
indicate the status of the charging process:
Red LED
Status
Green LED
status
Charger status
Off
Off
No power
Off
On
Standby mode:
- No battery is inserted or,
- Battery inserted but charging
has finished
On
Off
Battery charging in progress
• Fully charging the 2Ah battery may take up to
60 minutes.
• Fully charging the 4Ah battery may take up to
120 minutes.
After the battery is fully charged remove the charger
plug from the outlet and remove the battery from
the charger.
When the machine is not being used over a
longer period of time it is best to store the
battery in charged condition.
Application (Fig. D)
For this tool, use one of the following length for
staples or nails:
• Staples: Type 55: 15-25mm
• Nails: Type 47: 15, 20, 25, 30 or 32mm
Loading the nails or staples (Fig. DG)
• Choose the correct nail or staple for the job.
• Place the tacker (1) on its side with the battery
(2) pointing to the right, like show in fig. E.
• Open de cartridge shaft (6) by slightly pressing
the reload lever (7).
• Pull the reload lever (7) to the right to open the
cartridge shaft (6).
For nails:
• Place the nails at the top of the cartridge shaft
(6). Like shown on the label of the cartridge
shaft, see example fig. F.
For staples:
• Place the staples at the bottom of the cartridge
shaft (6). Like shown on the label of the cartridge
shaft, see example fig. G.
• Slide the cartridge shaft (6) back until it clicks.
Summary of Contents for S2 SG503DC
Page 2: ...WWW VONROC COM 2 A B C 6 8 10 7 2 11 4 5 1 9 3 2 1 2 2 14 13 12 15 15...
Page 81: ...81...
Page 82: ...82...
