6
EN
WWW.VONROC.COM
temperature range specified in the instructi
ons.
Charging improperly or at temperatures
outside the specified range may damage the
battery and increase the risk of fire.
6) Service
a)
Have your power tool serviced by a qualified
repair person using only identical replacement
parts.
This will ensure that the safety of the
power tool is maintained.
b)
Never service damaged battery packs.
Service
of battery packs should only be performed by the
manufacturer or authorized service providers.
ADDITIONAL SAFETY WARNINGS FOR DRILLS
AND SCREW DRIVERS
Drill safety warnings
a)
Wear ear protectors when impact drilling.
Exposure to noise can cause hearing loss.
b)
Hold the power tool by insulated gripping surfa
ces, when performing an operation where the
cutting accessory may contact hidden wiring.
Cutting accessory contacting a “live” wire may
make exposed metal parts of the power tool
“live” and could give the operator an electric
shock.
c)
Brace the tool properly before use.
This tool
produces a high output torque and without
properly bracing the tool during operation, loss
of control may occur resulting in personal injury.
SAFETY INSTRUCTIONS WHEN USING LONG
DRILL BITS
a)
Never operate at higher speed than the maxi
mum speed rating of the drill bit.
At higher
speeds, the bit is likely to bend if allowed to
rotate freely without contacting the workpiece,
resulting in personal injury.
b)
Always start drilling at low speed and with the
bit tip in contact with the workpiece.
At higher
speeds, the bit is likely to bend if allowed to
rotate freely without contacting the workpiece,
resulting in personal injury.
c)
Apply pressure only in direct line with the bit
and do not apply excessive pressure.
Bits can
bend causing breakage or loss of control, resul-
ting in personal injury.
SAFETY WARNINGS FOR BATTERY
a)
Do not open the battery
. Danger of short-
circuiting.
b)
Protect the battery against heat, e. g., against
continuous intense sunlight, fire, water, and
moisture
. Danger of explosion.
c)
In case of damage and improper use of the bat
tery, vapours may be emitted. Ventilate the area
and seek medical help in case of complaints
.
The vapours can irritate the respiratory system.
d)
Use the battery only in conjunction with your
Vonroc product
. This measure alone protects
the battery against dangerous overload.
e)
The battery can be damaged by pointed objects
such as nails or screwdrivers or by force
applied externally
. An internal short circuit can
occur and the battery can burn, smoke, explode
or overheat.
FOR THE CHARGER
Intended use
Charge only CD813AA type rechargeable battery
packs. Other types of batteries may burst causing
personal injury and damage.
a)
The appliance is not to be used by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they have
been given supervision or instruction
b)
Children being supervised not to play with the
appliance
c)
Do not recharging nonrechargeable batteries!
d)
During charging, batteries must be placed in
the well ventilated area!
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable
for the power rating of the machine with a
minimum thickness of 1.5 mm
2
. If you use a ex-
tension cable reel, always fully unroll the cable.
2. MACHINE INFORMATION
Intended use
This cordless drill is intended for driving in and
loosening screws as well as for drilling in wood,
metal and plastic.
