Here’s how you set Control Switcher’s switch functions:
1.) Apply power while holding down button #4. The LEDs will flash until you
release the button.
2.) Press each button to set the corresponding swi
tch’s function. The LED
indicates the setting.
LED
Switch Function
Off
Normal
On
Reverse
Regular, Fast Blink
Momentary; Pulse On/Off
Irregular, Slower Blink
Momentary; Pulse On Only
3.) Remove power when finished.
Factory Reset
You can restore all of the factory default settings and clear any saved presets by
the following steps:
1.) Apply power while holding down both buttons #2 and #3. The LEDs will flash
until you release the buttons.
2.) LED #1 will be on. Press button #1.
3.) Press buttons #2, #3 and #4 as each LED comes on.
4.) When the reset is complete, the LEDs will blink three times and then stay off.
Remove power.
